Cincinnati Milacron
Hello, Need help !
On Acramatic 850 display, after axis algnament I have an error (00327 X axis open loop).
The resolvers look OK. Could be +/- 15 V ?
On the axis Drive Board I don't have the LED +/- 15V ON.
After the axis alignament, after 5-10 seconds, the error apears and on display X & Z axis position info is changed.
Normal positions are:
X = 4.2000
Z = 10.000
At error:
X = 4.0683
Z = 9.8362 without axis moving
and this situation is permenent after each start up.
The start up diagnosis is correct each time.
Any info will be appreciated,
Marius Borza
In electronics you can try once... and go home !