[AZDEN]

Hi All,

I have a custom macro program that calls a cutter compensation, D#4107. The machine tool builder wrote the program initially and I need to modify it. I'm pretty good at writing programs but for the life of me I cannot find this offset value in any screens. I do not have a manual for this controller but do have one for a O-MC. Can anyone help me find this value?

Thanks for your help.

[dcoupar]

System variables on the 0M-D should be the same as the 0M-C

#4107 is the active (modal) D.

If you MDI the following:

D21;
#101=#4107;

INSERT
CYCLE START

You should be able to go to the Offset display, hit > until you see MACRO, then cursor or page down to #101, it should contain a value of 21.