It's a non-asbestos heat proof pad, rigid, one quarter inch thick. It's off white with sparkly bits and I need to mill a fancy insulating washer out of it.
Anyone know this stuff and what it is made of? Came without a HazMat sheet. It feels like a cross between MDF and a ceramic wall tile.
Just wondering if I need to take extreme dust precautions and cut under water?
Results 1 to 3 of 3
-
10-24-2007, 10:09 PM #1
Registered
- Join Date
- Mar 2007
- Posts
- 534
Cutting heat proof material. Is it safe?
-
10-24-2007, 10:20 PM #2
Gold Member
- Join Date
- May 2005
- Posts
- 1810
When in doubt, take the safest route.
I think I know the material you are talking about. If it's the material I think it is, it's really brittle and hard. I have no idea what it is.
Good luck and be careful!
ScottConsistency is a good thing....unless you're consistently an idiot.
-
10-25-2007, 07:47 PM #3
Registered
- Join Date
- Mar 2007
- Posts
- 534
I woke up this morning with a chesty cough, luckily I hadn't cut the whatever it is yet or I'd have been worried
Reply With QuoteSimilar Threads
-
to heat or not to heat - that is the question?
By stirling in forum Stepper Motors / DrivesReplies: 15Last Post: 09-04-2007, 09:44 AM -
From clipart to Mastercam to cutting material
By ardessi in forum CNC (Mill / Lathe) Control Software (NC)Replies: 0Last Post: 01-29-2007, 03:18 AM -
Cutting G10 material without metal tools? (CNC milling)
By burnthills in forum MetalWork DiscussionReplies: 5Last Post: 11-01-2006, 08:34 PM -
Is this safe?
By Hack in forum DIY CNC Router Table MachinesReplies: 3Last Post: 07-28-2005, 01:00 AM -
Is it safe?
By kong in forum Gecko DrivesReplies: 1Last Post: 11-24-2003, 04:56 PM
Posting Permissions
