I use this drive model Baruffaldi turret Type : DMS-08BF
I recently had a problem and the error 9.2 is displayed on the drive
Please advise how to fix this error
Do you have the list of alarms, please give me
Best Regards
[email protected]
I use this drive model Baruffaldi turret Type : DMS-08BF
I recently had a problem and the error 9.2 is displayed on the drive
Please advise how to fix this error
Do you have the list of alarms, please give me
Best Regards
[email protected]
Just visit the Baruffaldi website and scroll down to the bottom: https://www.baruffaldi.it/en/manual/
You can contact them because you need a login for download.
I have a pdf for the newer DB21 - drive, but the pdf for the one you have is also for download.
This is what my DB21-drive pdf says:
9.2 Zero search in operative mode different from 1 - Code 29
The alarm is activated after the START command, before unlocking the turret when:
- Operation Mode (=)> 2
- Position code = 0
- Check code management of the position in the plc.
- Check wiring of connector J1
HI Men
Thank you very J1 connector completely, there is no problem.
Do I have to look for problems in the device controller software (FANUC Series OI-TD)?
Is it possible that the drive is defective?
What does this mean?
- Operation Mode (=)> 2
- Position code = 0
To solve ((((this issue - Check code management of the position in the plc))).
Which part of the controller should I refer to?
Is there a way to ignore(BY PASS) this error or must the problem be solved?