Mach3, SmoothStepper ESS, C25 BOB, Gecko 540 driver, 2021 screenset
Proximity Sensor: type LJ12A3-4-Z/AX. NPN NC 6-36V
Resistor: 330 ohms 2%
V Diode: 0.5W 4.7V
DC Transformer 12VDC
The C25 BOB requires a voltage 5V or less to operate normally.
I am attempting to add proximity sensors to me homing and limits.
My problem is that I have been unable to get agreement on the wiring for the proximity circuit.
There are three connections on the Proximity itself. Black being the output to the Input of the BOB, Brown connecting to the +Voltage and Blue to GND. This is what I have found on the internet.
Here is the circuit drawing that I have, it or the components must be in error because I measure only 0.6V
When it is near metal or not. The LED cycles on and off as expected when near metal. See circuit for measurements taken at various places.
Please let me know where I am in error.
Thanks
Hager