[turbotronic]

Hi,
My Syil X4 spindle driver let go and I replaced it with a bigger motor that uses this Driver. The docs I have give no clear clue as to how to either have PWM or 0 - 10V input active. Via keypad entry I can run the spindle fine but I need to i/f with Mach3 via my Ethernet Smoothstepper.
Looks like the CN1 could be some serial and or CAN i/f.
Any help would be really appreciated.
Andre

[cncmakers001]

[QUOTE=turbotronic;2554758]Hi,
My Syil X4 spindle driver let go and I replaced it with a bigger motor that uses this Driver. The docs I have give no clear clue as to how to either have PWM or 0 - 10V input active. Via keypad entry I can run the spindle fine but I need to i/f with Mach3 via my Ethernet Smoothstepper.
Looks like the CN1 could be some serial and or CAN i/f.
Any help would be really appreciated.
Andre

This AC servo driver looks similar to DA98A AC servo driver, maybe you can refer to the DA98A user manual at below page.
https://paycnc.com/da98a-15-ac-servo-driver_p0856.html

[turbotronic]

[QUOTE=cncmakers001;2554818]

Hi,
My Syil X4 spindle driver let go and I replaced it with a bigger motor that uses this Driver. The docs I have give no clear clue as to how to either have PWM or 0 - 10V input active. Via keypad entry I can run the spindle fine but I need to i/f with Mach3 via my Ethernet Smoothstepper.
Looks like the CN1 could be some serial and or CAN i/f.
Any help would be really appreciated.
Andre

This AC servo driver looks similar to DA98A AC servo driver, maybe you can refer to the DA98A user manual at below page.
https://paycnc.com/da98a-15-ac-servo-driver_p0856.html

Thanx, will look into it and report if successful!