I purchased a used 3400 that came with Case Mate for New Hermes, it is currently hooked up with a parallel card (ECP) but when I try to send the job it gives an error that states
[ERROR LPT MODE IS NOT SUPPORTED] Can anyone help me with this?
TIA
Gary
Thread: New Hermes v3400 & Cas Mate
Results 1 to 1 of 1
-
07-11-2023, 12:40 AM #1
Registered
- Join Date
- Jun 2017
- Posts
- 369
New Hermes v3400 & Cas Mate
Reply With QuoteSimilar Threads
-
New Hermes v3400 post processor for Enroute?
By Shelby5041 in forum EnRouteReplies: 0Last Post: 09-10-2020, 04:12 PM -
Artcam Post Processor / Driver for New Hermes V3400?
By Shelby5041 in forum ArtCam ProReplies: 0Last Post: 08-27-2020, 10:25 PM -
Enroute and New Hermes V3400?
By Shelby5041 in forum EnRouteReplies: 0Last Post: 08-21-2020, 08:11 PM -
New Hermes EP controller module v3400
By karmakore in forum Engraving MachinesReplies: 1Last Post: 08-31-2009, 03:28 PM
Tags for this Thread
Posting Permissions
