[Michael82]

We just got a used 2014 HAAS VF-1 in our shop, and I need to get the pinout or wiring diagram to be able to wire the machine to the data transfer switch box that is in my programming office. We currently have a Doosan DNM500 milling machine, 2 Doosan Puma 400's lathe and a Doosan Puma 300 lathe. and they are all connected to the data transfer switch box, and they are all Fanuc series I controls. I have searched online for the pinout, but I can't find the one for db25 pin at the pc end and the db25 pin at the machine end. Is the Haas configured like the Fanuc? Can someone please help this is our 1st Haas machine in the shop, so we do not have any info on it besides the operator's manual and the internet .

[Donkey Hotey]

2014 machine? Do you have a serial port? If you have one, it's a standard RS-232, DB-25 serial connector. The manual shows it inverting wires 2 and 3 so it's a null modem cable to communicate with a PC. Not sure if your switch box is straight through or does its own null-modem swapping.

If it's got the next-gen control, I think you have to put it on your network via Ethernet cable.