I have an VM16 Milltronics machine with CNC Centurion 7. The machine performs one block in the program and stops, while there is no continuation of execution! What could be the problem? Thank you in advance, Victor.
I have an VM16 Milltronics machine with CNC Centurion 7. The machine performs one block in the program and stops, while there is no continuation of execution! What could be the problem? Thank you in advance, Victor.
The machine executes a single software block, then stops with no way to proceed. What could possibly go wrong?
https://amandatheadventurer.io/
It could be a couple things. 1. the following error is not dropping back to <.005 so it is waiting for that to happen ( " in position error")
2. possible bad CMOS battery and the BIOS had dropped back to "defaults" and the seetings are not correct.
Give me a call 952-288-6340
Sporty Bob
Thanks to Sporty Bob. The problem was in the bios. The settings of my bios were sent to me by the milltronics service. The problem is solved.
Sincerely,
Victor.