Hello all,

I have been using this cheap Chinese machine (CNC3020Z-D300) for the last 7 years, but unfortunately the hard disk crashed and I lost the manufacturer's parallel port settings. Manual and disc are unfortunately long gone.


https://www.aliexpress.com/item/32764954708.html

The original supplier no longer stocks them and I don't expect much help after so long.

I've found another Windows XP machine and installed Mach3, but I can't configure the parallel port properly.
If anyone could share a screenshot of the parallel port setup screen, I'd be very grateful as it would get me out of a real bind.

Thanks all.