Hi
I am hoping to clarify an important point for me.
A friend of mine wants to draw up a 3D part in Rhino, and have me cut it on my (under contstruction) DIY 3 axis router.
The router will be running Mach III (at least, that is the plan)
I don't own a copy of Rhino, and have no plans to buy it, at least near term.
Questions
1) Can I use a 3D CAD file from Rhino (emailed to me), load it into a stand- alone copy of Mesh CAM, and make tool paths / G code from it ?
2) Can the cut viewer software see the entire image of what is going on with the part and tool paths run in this mode (no Rhino s/w)
Thanks