On initial power up wherever the selector knob is for jog, X,Y or Z it gives an alarm. If you move the selector to a different axis it will alarm out that axis. Screen message amplifier fault. Point my in a direction please.
On initial power up wherever the selector knob is for jog, X,Y or Z it gives an alarm. If you move the selector to a different axis it will alarm out that axis. Screen message amplifier fault. Point my in a direction please.
...low input Voltage? Low air pressure? wow that is weird thing happen.
208vac input all three phases.
208vac input all three phases. 120psi to the regulator.
...in SETP there is a 5% low voltage setting...could maybe try that.
reskinner? Any ideas? It's almost as if the amps are not even being turned on.
...try calling these guys...they helped me on the phone hooking up a 4th axis for no charge. Great Folks
For Help, Call or Text (406) 600-0624
https://nxgenparts.com/axis-amplifiers/
good luck,
DJ
check power supply voltage
12v and 5v
input 120v ac
check jumpers on transformer for correct output voltage
check blue capacitor voltage between 125to160
vdc depend on type of transformer
check fuse f17 and k1 relay
and finaly reset motor overload relay on amps chassis