[erhanery]

Hi everyone ,

I have a miyano lathe with c and Y axis. However I cant use C axis with "C" chamfering command. ;

X42 C2; ( when parameter CCR open)
z-20 ;

When I write this You cant use C when you dont activate C axis mode (waiting M13)

I heard , I must use "," somewhere but where ? Do you have any ideas ?

Thanks

[Dale123]

Try X42,C2.
Z-20.

[sinha_nsit]

If using "chamfering and corner rounding," set CCR to 0 and use I-K method.

[sinha_nsit]

I have a detailed answer, but the server is not allowing to post it. Don't know why.

[RaderSidetrack]

I have a detailed answer, but the server is not allowing to post it. Don't know why.

Some potential issues might be attachment related (oversize) or (improper file type); sometimes including email addresses bumps a message into 'moderated' status.

I'd troubleshoot this by just posting text, then if that works edit it to add attachments one at a time. Or add more in successive posts.

If you can't post the text alone, there could possibly be some special character in there causing the problem. Send me a PM and I will reply with my email address. Then email me the content of your message and I will find the issue.

[sinha_nsit]

It was a copied text from the Word file of one of my books. IIRC, the server was throwing Error 503.
Maybe I did something wrong. Will be more careful next time.

[RaderSidetrack]

If you can't post the text alone, there could possibly be some special character in there causing the problem. Send me a PM and I will reply with my email address. Then email me the content of your message and I will find the issue.

[sinha_nsit]

It contained this special character

#

Let us see if it is accepted this time.

[sinha_nsit]

If you can't post the text alone, there could possibly be some special character in there causing the problem. Send me a PM and I will reply with my email address. Then email me the content of your message and I will find the issue.

So, the special character was not the issue.
Possibly, some specific format caused the problem. Or, maybe, some temporary issue with the site.
If I face this problem again, I will pm you.