[ruthain]

Hi there, I am Ruthain here,
I have Anilam CNC mill that now pops up on the screen of the machine at the boot up an error message saying:

"CCU DL TIMEOUT.
ERROR LOADING CCU FIRMWARE!!! C\:>P6M"
Unfortunately, the manufacturer of the machine doesn't do the support anymore but they suggested I look at the DSP board of my machine. So, my technician suggested replacing the chip could be a better option.
The firmware details of my controller are:
"Anilam 6000M CNC Software
Version 3.05A
CCU firmware version 246280.10"
Does perhaps anyone here knows how o go about solving this issue please?
Thank you
Best regards
Ruthain

[machinehop5]

...does this Anilam CNC have a HDD? Does it have a CMOS Battery that needs replaced or has been replaced? ..... If, so your BIOS settings would need to be reset.
DJ

[ruthain]

Hi DJ, Yes, My CNC has HDD and a CMOS Battery which i replaced already and i tried the BIOS settings but i only do some minors reset. Yet it still gives me the same error message over and over. Do you mind perhaps help me out with the proper way of resetting the BIOS maybe?

Thank you in advance

[ruthain]

I even tried replacing the HDD by a new one yet still gives me the same error message