At work we have a HASS st20 and st25 which use single line G76 however I can't find the spring pass setting is it in there somewhere lol?
If not can I use the 2 line G76 so I can specify the amount of spring passes?
At work we have a HASS st20 and st25 which use single line G76 however I can't find the spring pass setting is it in there somewhere lol?
If not can I use the 2 line G76 so I can specify the amount of spring passes?
There is a setting for minimum pass size but, if you want a spring pass or multiple spring passes, G92 is what you seek:
https://www.haascnc.com/service/code...value=G92.html
Make sure to use the same Z start point and parameters as your G76 but, enter the X value for each individual pass you want to add.
Greg