[jubee]

Hi All,
Is there such a parameter that enables the 4th axis with Fanuc OM controller ?as I cant see any physical switch that turns on A axis
Also ,On the screen it doesn't show a A axis position ? can that be enabled as well ?

I have nearly googled myself to death......going round and round ;(

I bought a VMC with Fanuc Om that came with a rotary axis and the seller told me it was all set up for it.


Any help or walk throughs would be great and much appreciated , if anyone had some ideas.
Thanks

[cncmakers001]

Hi All,
Is there such a parameter that enables the 4th axis with Fanuc OM controller ?as I cant see any physical switch that turns on A axis
Also ,On the screen it doesn't show a A axis position ? can that be enabled as well ?

I have nearly googled myself to death......going round and round ;(

I bought a VMC with Fanuc Om that came with a rotary axis and the seller told me it was all set up for it.


Any help or walk throughs would be great and much appreciated , if anyone had some ideas.
Thanks

It seems the 4th axis is optional, need to buy from Fanuc company, you can check with Fanuc guys.

[jubee]

It seems the 4th axis is optional, need to buy from Fanuc company, you can check with Fanuc guys.

It's all been installed , just I can't see
How to get it operating ....
The screen only shows 3 x axis....
But guy I bought it from was using the 4 axis

[memoryman]

Download the NC parameters, including the 900s and send them to me [email protected]

[jubee]

Thanks for this ....????????

I havnt downloaded the 900 parameters before ...will need to find out how to do this ...
Will try later ...thank you

[jubee]

Thanks for this ....????????

I havnt downloaded the 900 parameters before ...will need to find out how to do this ...
Will try later ...thank you

sorry not sure why all the question marks ........lol I think fat fingers or emoj or something.
Also i cant edit the post , not sure why

Anyway just sent you an email, very grateful for this Thank you

[jubee]

Those following ..................
Fixed
Very Big thanks to [email protected]

907 Parameters not enabling 4th Axis
so it should look like 01001100

2 Axis control, 3 simultaneous
3 4th axis control
6 Cutter Comp. C

Also , which i didn't know
bits are counted from right to left starting with #0,