[blmac515]

When I try to start up my TRM I get this message: UNRECOVERABLE MEMORY ERROR AT FFF9. I found a procedure titled:
Zero Memory Procedure. The first thing it says to do is cold start. I am unable to do that as the machine will not move. would I be able to try said procedure without doing a cold start if it will let me?

[machinehop5]

...if possible write down or transfer your Tool information, if needs to be saved. There is the BL command to save Bachlash values. And most importantly your Parameters should be saved. There are some Home Offsets for each Axis but, these are stored on each Axis eeproms on later model Fadals. If, no Tool Changer then no big deal for Z Home aka CS. Following the manual to Zero Mem you shouldn't have any problems. Thanks FADAL.

DJ