Hi!
I switched on OKUMA LB15II OSP7000 (build in 1999).
Got this message. What is the problem? In memory board or I need to reinstall OSP.
I tried to insert install floppy, but instalation process not started.
Hi!
I switched on OKUMA LB15II OSP7000 (build in 1999).
Got this message. What is the problem? In memory board or I need to reinstall OSP.
I tried to insert install floppy, but instalation process not started.
You must initialise CMOS memory first. Then you can install software
Looks like I have only Bubble memory.
I have no CMOS in my lathe
OSP7000 control units doesn't have buble memory type.
"Imagination is more important than knowledge."
How can I initialase CMOS?
I did not remember such procedure in Maintenance Manuak for my LATHE
- Power off
- Insert 1st floppy (install disk #1)
- Power on
- Type A;H when menu appears on screen
"Imagination is more important than knowledge."
Thank you!
Tomorrow will check and replay about result.
Sorry, not helped...
same error 128 Memory Disk Format ERROR after battery low
when battery diskete load and try format - bus error
how iinitialize SRAM memory?
I am making retrofit. Bought CHINA TD1000 and 3 servo drice + servo motor. The price for all China kit was 2000 USD + 2200 USD work.
It is more effective then try to up old machine.