[spikee]

Hi All,

I have been working on enabling macro B on my Fanuc 0M-C but it seems like it does not "stick".
(param 912 Macro A is also 0x00)

My sequence is as follows:

machine on -> pwe 1 -> estop -> parameter 913 set to 10000000 -> input -> get p/s 000 error. I was in mdi mode when trying to edit it. Write protect key (allow write).
Have tried a re-start and re-boot (as that is what error 000 means) but that does not seem to help.

Al_The_Man Seems to remember the following:
"... many of my notes are no longer around, there is a parameter to set to allow it to be enabled which I cannot find at the moment. will keep on looking."

Perhaps somebody else seems to remember it?

[phucrobusl]

902-01000000
917-00010000
912-10000000

[memoryman]

p/s 000 alarm means that the control power has to be cycled.

[spikee]

Yeah i did that. but it does not "stick" . I tried just turning it on and off with the putton on the frontpanel and by rebooting the system by means of the mains switch.
Parameter 913 stays at 0x00; i will try to do the parameters that phucrobusl sent. Perhaps it is missing another parameter to allow 913. I'm not sure.

[memoryman]

Are you leaving the other bits (x) unchanged?
902-x1xxxxxx macro A
917-xxx1xxxx macro variables 600
912-1xxxxxxx macro executer
913-1xxxxxxx macro B

[spikee]

Are you leaving the other bits (x) unchanged?
902-x1xxxxxx macro A
917-xxx1xxxx macro variables 600
912-1xxxxxxx macro executer
913-1xxxxxxx macro B

So far i have only changed 913. But i will try the above parameters. I will leave the x unchanged.

[spikee]

I just checked my backup and current settings is this:
902-x1xxxxxx macro A = 01000000
917-xxx1xxxx macro variables 600 = 00000000
912-1xxxxxxx macro executer = 00000000
913-1xxxxxxx macro B = 00000000

[spikee]

So I tried it on the machine and 902, 912 i'm able to change. However when i do 917 or 913 it does not stick.
I made a video to show it happening:

Any ideas?

[memoryman]

What is your software? You may not have the eproms for the macro B option.

[spikee]

What is your software? You may not have the eproms for the macro B option.

When i start the machine the following is on the screen:
0453 - 03
PMC 5B03-01

How can i check the software version?

[memoryman]

0453 - 03 is the software. My option list shows that 0453 does not support macro B.