[ManosCNC]

Hey guys!

I have this problem that every time I wanna run a simulation the Simulator windows just showing up and then suddenly it's closing. No error message, nothing. I've already updated the latest version of my windows(WINDOWS 11 PRO) and graphic card (AMD RADEON RX6600)

Everything else is working fine.I am using the student version of EDGECAM 2023.

It's a newly installed Windows, it has never seen any other EdgeCam yet.

Anyone have some solution for this?

[Vegabond]

Hi,

What version do you use?

[ManosCNC]

Hello thank you for reply

I am using 2023 student version, with the only difference that it is not generating code. I was informed that i have a driver issue with graphic card, i fixed it and with all the latest updates, but simulation still not working

[Vegabond]

Ok, there is a program that you can completly remove ALL graphic drivers, but i don`t remember the name..
You can try to clear cache under the miscelanious tab, and then restart the simulator. In the simulator settings i would have checked the box "Quit on close" that vil totally reload the file before simulation.

[shige]

Check the Use Software Rendering only checkbox in the settings and give it a try.