Hello, I'm new to forum (and Arduino) so I hope I'm asking this correctly.
Does anyone have any advice/guidance for interfacing a UNO to a Leadshine DM556 driver?
https://www.oyostepper.com/goods-124...per-Motor.html
PDF:https://www.oyostepper.com/images/upload/File/DM556.pdf
I'm planning to use a NEMA 34 motor to drive the Z-axis on small mill. No positioning, just want to control speed and direction.
Regadrs,
JD
Results 1 to 2 of 2
-
02-21-2024, 03:06 AM #1
Member
- Join Date
- Dec 2019
- Posts
- 4
Question about Leadshine DM556 Stepper Motor Driver
-
02-25-2024, 02:52 PM #2
Registered
- Join Date
- Dec 2012
- Posts
- 199
Re: Question about Leadshine DM556 Stepper Motor Driver
You can connect the UNO direct to the DM556.
The DM556 has optocoupler inputs that will work direct connected to the UNO.
connect the +5v of the uno to PULL + and DIR +
connect any two digital outputs to PULL - and DIR -
connect your motor and power supply to the DM556
program the Arduino and go for it
Reply With QuoteSimilar Threads
-
Replacing a Tormach 3-Phase stepper driver with a Leadshine driver
By Titaniumboy in forum Tormach Personal CNC MillReplies: 4Last Post: 02-10-2024, 11:15 AM -
Leadshine M542 Stepper Driver 4.2A 50V for 2/4-phase Hybrid Stepping Motor
By willamwang in forum Servo Motors / DrivesReplies: 0Last Post: 04-27-2016, 10:05 AM -
Leadshine DM556 stepper motor driver.
By Kingjamez in forum Stepper Motors / DrivesReplies: 6Last Post: 08-02-2009, 03:22 PM
Tags for this Thread
Posting Permissions
