Hello, I apologize if this is the wrong place to post this
Just for clarification I don't work with any CNC equipment, I'm only posting here because I know these are FANUC Honda connectors
I recently purchased a 12" Toshiba monitor off ebay, it was real cheap so I wasn't too concerned about quality and I must have overlooked how it even connects to anything. Upon unboxing it I found a detachable board with a 6-pin presumably power connector and two 16-pin connectors, which after some research I found these are Mr-16 Honda connectors. Looking through these forums and some manuals it seems that most monitors for FANUC systems are either 9" or 14", and use 20-pin connectors, which is a little odd
Since I am trying to wire this to a computer's VGA port as I'm not using it with a FANUC system, I was wondering if anyone would happen to know the pinout of this connector and if it's even possible to do what I'm trying to do or if I should just return the monitor
I attached 3 pictures of said board and monitor
Again sorry if this is the wrong place to post this