Hello,
I just started with Madcam for rhino and we use a Masterwood mw 2142
its all bit new for me and i have put in my mills and i been able to make a file where i can see that the machine sees the drawing and he picks up the mill and starts turning.
But i saw when i tried to test run it that is was going to deep.
and im getting stuck with Z axis, i changed my feed xy feed z and spindel but now i get an error message.
Dont know what im doing wrong.
i hope im correct
max rpm x1000 is the spindle speed
ingang snelheid translated is input speed
frees sneleheid translated is milling speed
But now i get notification stopt because error 2.1.1511. Input time out Bandalla aperta
Hope somebody can help me abit.
Kind Regards