I have one of those inexpensive touch down probes as shown in the first image below. I have it wired to Port 2, Pin 15 on my C76 board. The probe base is wired to Pin 15 and the probe alligator clip is wired to COM. I get no response to the indicator light on the DIAGNOSTICS screen when I touch the alligator clip to the probe base.
On the C76 on Port 2 I have the two jumpers set to COM=5V as shown below. I don't believe I touched these during setup a few years ago as I have nothing else coming into the Port 2 inputs.
I suspect these jumper settings are the issue. Could someone confirm before I go experimenting?
Thanks,
BH
Attachment 503254