Hello - I am seeking a machine tool end user / specialist or technician who has experience setting up Renishaw probing on a Fanuc control. I have a 3-axis VMC with a Oi-MF Plus control with two HSS inputs enabled, one of which is currently utilized by a TS27R tool setter. I need assistance with adding a RMP40M + RMI probe to the system, specifically around the wiring of the required relays and setting + confirmation of the parameters / ladder logic and use of macros.

I have the hardware, the machine tool schematics and the Renishaw macros but what I don't have is the experience to wire and configure the probe for use.

If this interests you, please PM me with your information and rate. I would be open to a remote engagement if there's a strong fit but would prefer local folks due to the hands on nature of the task.

Thanks in advance for reading this!