586,096 active members*
3,766 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Daewoo/Doosan > puma 2500 sy nc wont start

Thread: puma 2500 sy nc wont start

Results 1 to 3 of 3
  1. 03-28-2024, 05:33 PM #1
    dimitrisvv
    dimitrisvv is offline Junior Member
    Join Date
    Jun 2018
    Posts
    3

    puma 2500 sy nc wont start

    hello . I have a doosan 2500 sy and all though everything was working properly yesterday, this morning the NC control didnt start. I checked the fuse behind the screen but it was ok.
    I would apreciate your imput on this .
    thank you
    Reply With Quote Reply With Quote
  2. 03-29-2024, 12:57 PM #2
    dimitrisvv
    dimitrisvv is offline Junior Member
    Join Date
    Jun 2018
    Posts
    3

    Re: puma 2500 sy nc wont start

    thank you for your reply. on the nc control there is the cable WJ01 with the plug XCP1A that is pluged on the contror next to a fuce . if this is the power supply then this plug has no power. is there something i need to check? thanks
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Heidenhain TNC 2500 wont accept the number I when put in !!
    By beemergb in forum HEIDENHAIN -> GENERIC
    Replies: 1
    Last Post: 06-01-2022, 05:41 PM
  2. TNC 2500 wont reference
    By iruss265 in forum Bridgeport / Hardinge Mills
    Replies: 2
    Last Post: 01-05-2019, 10:31 PM
  3. Puma Mx series 2500 lst atc cycle problem
    By mystiks in forum Daewoo/Doosan
    Replies: 2
    Last Post: 05-25-2010, 05:36 PM
  4. Daewoo Puma 2500 vs Mori Seki NL2500SY Lathes
    By frogier in forum Daewoo/Doosan
    Replies: 34
    Last Post: 09-22-2008, 02:10 AM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules