[grc]

I'm getting a Error on the Servo Control for a bar feeder. It says "Ser Err" does that mean Servo Error or Serial Error. Also any ideas what to check first.

Thanks

[cncmakers001]

Ser-Err (Servo Error) during first home find initiation.
Ser-Err (Servo Error) upon indexing.

Possible causes:
1- Faulty main cable or cable connector.
2- Table driving a heavy load.
3- Table is jammed.
4- Check Parameter 25.
5- Head is iammed

Solution:
1- Check cable and motor fuse.
2- Reduce workload weight and/or feed rates.
3- Eliminate obstruction.
4- Must be set to 8 for HRT 160, 210, 450 (19 for HRT 310)
5- Eliminate obstruction

[grc]

Attachment 504004

Here is a picture of the Servo Driver