Hi everyone, i know this must have been asked before but i'm stuck,
i have a Nema 23 equivellent stepper motor they are 8 wires & this is where i get stuck?
A:BLU/WHT
A':BLU
C:RED/WHT
C':RED
B:GRN/WHT
B':GRN
D:BLK/WHT
D':BLK
i need to wire them to a board that is 1A 1B 2A 2B this is the bit i'm stuck with, i know you can wire them serial or parallel but what wires do you connect to each other.
Should i connect the BLUE & the RED and GREEN & BLACK and then use the BLU/WHT AS A1 & RED/WHT AS A2 ALSO THE GRN/WHT AS B1 & BLK/WHT AS B2.
i hope this makes sence if someone who knows what there doing that could explain
cheers steve