Does anyone know is it possible to edit ladder on Fanuc 10T?
Does anyone know is it possible to edit ladder on Fanuc 10T?
On the machine? No. There is a PMC cassette in the machine (looks like an 8-track tape) which contains the EPROMS / Ladder. This must be erased and re-programmed outside of the machine (typically), or replaced with a new cassette/ Ladder.
Paul Sevin - Ovation Engineering, Inc.
http://www.ovationengineering.com
Thank you very much. Could you telling where I can get PROM programmer and software for PMC?
Best regards.
There is a company in Canada that can give you the service, check www.memex.ca, the cost is depending of what you want.
GP.