We have a Fadal VMC15 and are getting the following error at power up.
X axis Fault
Error #1
Motor Overload
We switched the X and the Y amp card and get the same message. What should we try next?
Thanks for any help anyone can give us.
We have a Fadal VMC15 and are getting the following error at power up.
X axis Fault
Error #1
Motor Overload
We switched the X and the Y amp card and get the same message. What should we try next?
Thanks for any help anyone can give us.
I took the X axis resolver and swapped it with the Z and the problem went away. Switch them back and the problem comes back. Any body have any ideas?
A new motor fixed the problem.
The VMC 15 has DC servo motors. You can replace the resolver with out replacing the motor. The error code #1 means no feed back signal from the resolver to the controller card.
Neal