I want to buy some wire loom devices like I've found in the panel of my CNC mill. These are channels with fingers pointing up. Wires are run into the channel inbetween the fingers and once all wiring is complete, covers snap across the top more or less sealing the mess inside the channels. What are these called? I have no luck in my searches using "wire loom."
Thread: Generic name/term needed
Results 1 to 3 of 3
-
12-22-2007, 07:31 PM #1
Registered
- Join Date
- Oct 2005
- Posts
- 1237
Generic name/term needed
-
12-22-2007, 08:15 PM #2
Registered
- Join Date
- Oct 2005
- Posts
- 1238
Try this site for some similar to your description.
A search for "cable management" might give some results as well.
-
12-22-2007, 08:53 PM #3
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24221
I think you are describing Panduct, made by Panduit, also other manuf offer similar.
Wiring trough is another description.
http://www.panduit.com/products/PDFCatalogs/068548.pdf
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Reply With Quote
Similar Threads
-
Wiring Diagram for Generic Breakout board, home and Limit Switches, Generic Drives.
By CJL5585 in forum Open Source CNC Machine DesignsReplies: 33Last Post: 02-24-2010, 10:39 PM -
Minor changes to Generic Fanuc Posts....
By gearsoup in forum Post Processors for MCReplies: 2Last Post: 06-01-2007, 04:32 PM -
1/4 - 20 generic vs acme?
By 9xnet in forum DIY CNC Router Table MachinesReplies: 5Last Post: 05-06-2007, 05:55 PM -
Need someone to edit generic MPFAN 9
By CApostman in forum Post Processors for MCReplies: 6Last Post: 04-14-2007, 04:02 PM -
Generic(cheap) Encoder Source
By mikkojay in forum Servo Motors / DrivesReplies: 25Last Post: 04-01-2006, 10:27 PM
Posting Permissions
