[Brian FRF]

Anyone have a data list of parameter both program and machine?

Got our cent 4 up and going, except for one issue (so far). Has a 200 or 250 ipm rapid, thats fine. However, I cannot get actual feed to run faster than 5 or 10 ipm. Odly, the feed rate override seems to do nothing when its doing this, it just runs and (im guessing) a preprogrammed in max feed rate. The machine was used in a school for some time, so we believe they overrode the params to keep kids from running at 70 instead of 7 accidentally.

Im looking around as well.

[captainasty]

Give this a whirl.

[Brian FRF]

Got that page of the manual. A quick call this morning to milltronics got me someone who got me the params for this machine, based on serial number. about 5 minutes later and we had our feeds running correctly.

Im going to copy over them, or take a picture and post it up for anyone else who may need it in the future.

[Ben Colby]

Once you get the parameters the way you like them, back them up on your PC.
You will be glad you did. If your battery dies or your memory gets reset or corrupted
you will lose all your parameters.

Just a thought
Ben