I am in the process of testing a new control and I am getting something quirky when using the G41 & G42 and I am not sure if it is me, my post processor or the control itself. I am trying to mill three circles with a Z feed in and Z feed up between each circle, What happens it come to the Z axis moves, wether rapid or feed down, I get a simultaneous X or Y move as though it is moving in and out of radius correction mode when moving between circles.
This is a sample of code, Can anyone see where the problem might be.
%
O12
N10 T1 M6
N20 G90 S3200 M3
N30 G0 Z.1
N40 Y-.25
N50 G0 G41 X0 Y.25
N60 G1 Z-.125 F28.
N70 G3 I0 J-.25
N80 G1 Z-.26
N90 G41 G3 I0 J-.25
N100 G0 Z.1
N110 G41 Y.6
N120 G1 Z-.125 F8.
N130 G3 I0 J-.6
N140 G0 Z.1
N150 G0 X0 Y.98
N160 Z.1
N170 G1 G41 F16.
N180 G3 I0 J-.98
N190 G0 Z.10
N200 X0 Y1.462
N210 G1 Z-.125
N220 G2 I0 J-1.462
N230 G1 Z-.26
N240 G2 I0 J-1.462
N250 G0 Z.1
N260 G40 G49
Thanks
Al