More Z axis no motion
Today I tried to fire up the mill and got the same alarm. e stop not working
Last week i started it up and it homed good, but i had a little problem getting the spindle to move but it did with a little help and I left it run for a while ,the machine has not been running in 256 days,
found what I think is the red estop wire had fell out of the contactor and went to ground so I replaced it to A2 but did not work ,need to do more checking of voltages
it is 105 in the garage and now getting a error when it tries to boot
07-29-2008 2:29:34 102 Error initializing CPU...cannot continue.
07-29-2008 2:30:00 Exiting CNC10 due to a known error (63)
Dual port base address = d0000
Timeout: 64180 not responding
Error occurred sending line 54
102 Error initializing CPU...cannot continue.
Return code 63
any ideas
will check volts in am
hope we can get this problem fixed
dose anybody have the username \password for ajax tech please pm me it has been awhile sence I had to use it
Thanks
IF ITS NOT BROKE YOUR NOT TRYING HARD ENOUGH
Ashes to ashes , dust to dust , If it wasnt for Harleys the fast lane would rust.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)