Hi Everyone;
Today's posting is an RFQ for a small quantity of parts for specialty lens mountings for industrial CCD cameras
There are two parts, both are aluminum, load is not an issue so alloy is not critical.
the rough description is...
Part #1, lens mounting clamp, qty 6
Milled part, appx 2.5” x 3.52” x .59” thick
Pocketed one side
Large 2.200 thru hole
4 small thru holes, 1 threaded hole
Part #2, lens flange tube, qty 9 total in 2 different lengths
Turned part, 2.200 OD x 0.6” (6 ea) or 0.8” (3 ea) long
Two internal steps in one end
One small notch in same end
One external groove near stepped end
ID not critical (mill finish OK)
Drawings are attached for both parts.
lens_clamp.pdf
lens_tube.pdf
Bids should be complete for materials, labor and shipping to Hillsboro, Oregon, 97006.
Material is any aluminum alloy, but we will be anodized for reflection control so preferably not 6020, which has too much copper to anodize well (at least where we do it).
Finish is standard clean, degreased shop finish, break all edges, blend toolmarks. These parts are not “appearance parts”, but they should have a reasonable surface finish, bright scotchbrite or similar finish is OK.
We will be anodizing these parts black. If your shop offers that service and you'd like to include it in your bid, please, by all means do so.
Delivery is two weeks.
Payment terms are negotiable, but in general, we can usually turn around a payment in a few days for something like this, and get you paid before you ship.
Please send any bids or questions direct to me at my work email. Because of some firewall issues on our office systems it's difficult for me to check CNCzone from my desk during the day to see replies left on the site.
My direct e-mail is...
Steve Switaj
Laika Studios
[email protected]
Additionally, if you just so happen to be a machine shop in the Portland/Hillsboro Oregon area, by all means, let us know. We're always keeping our eyes out for new vendors.
Thanks;
Steve