When I use the feed rate ovveride it increases the rapid and euqal amount. for example if increase a feed rate from 4 to 6 IPM then my rapid icreaes from 60 to 90 IPM.
Must be some box I need to uncheck or something EH.
When I use the feed rate ovveride it increases the rapid and euqal amount. for example if increase a feed rate from 4 to 6 IPM then my rapid icreaes from 60 to 90 IPM.
Must be some box I need to uncheck or something EH.
Try "No FRO on queue" in the general config. But be aware that this may cause a delay in the FRO. The recommended method is to increase the feedrate in your g-code and use the FRO to slow it down.
Some development work is currently being done to the FRO, expect some changes there in the near future.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)