586,108 active members*
3,293 visitors online*
Register for free
Login

Thread: tool change position on a mazak nexus mill 640m

Results 1 to 2 of 2
  1. 01-31-2008, 04:06 AM #1
    Denis13
    Denis13 is offline Registered
    Join Date
    Jul 2007
    Posts
    25

    tool change position on a mazak nexus mill 640m

    I measure a tool in semi-auto, then i do a tool change to measure another tool in semi auto, is there a way to change the tool change position so the table won,t move in y axis? because i would like not to have to move the y axis again to measure the next tool. Somebody asked me that question and i couldn't answer.
    Reply With Quote Reply With Quote
  2. 02-03-2008, 05:15 PM #2
    bigbobomb
    bigbobomb is offline Registered
    Join Date
    Jan 2008
    Posts
    65
    No you cannot stop the movement of any axis during tool change mode because it is a macro type program ste up at the factory for safety reasons.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. How to change Tool change position(About MAZATROL T1 control)
    By liushuixingyun in forum Mazak, Mitsubishi, Mazatrol
    Replies: 6
    Last Post: 01-07-2014, 01:33 AM
  2. eia restart problem on mazak nexus 640m mill
    By Denis13 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 1
    Last Post: 02-04-2008, 03:58 PM
  3. center drill diameter developpement on mazak nexus 640m mill
    By Denis13 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 0
    Last Post: 01-31-2008, 03:56 AM
  4. Mazak Nexus 640 Tool Turret problems
    By chattwo in forum Mazak, Mitsubishi, Mazatrol
    Replies: 0
    Last Post: 09-21-2007, 05:27 PM
  5. need post processor for mazak 640m nexus controller
    By Rcky123 in forum Mazak, Mitsubishi, Mazatrol
    Replies: 3
    Last Post: 04-06-2007, 08:23 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules