I have a Sherline mill, Deskcnc Controller, and Bobcad v.19 and so far nothing works right, lots of time and money spent, would really like to see some chips fly. Any help would be greatly appreciated. Thanx DJTOOLZ
I have a Sherline mill, Deskcnc Controller, and Bobcad v.19 and so far nothing works right, lots of time and money spent, would really like to see some chips fly. Any help would be greatly appreciated. Thanx DJTOOLZ
What types of problems are you having? I can help, if I can get a little mroe data.
Regards
Gee, good to see someone close by....
I have a MaxNC mill that works. Yea, I know you've read bad stuff about them but don't we read that about everything. :argue:
Just for your info I live by the Auglaze Golf course just off of State Route 111.
Jeff
Was just wondering if you had your sherline up and running yet.
Sent you a private message but didn't receive a reply.
I use BobCAD 22 and RamsGOLD for CAM.