Hi.
Took me 3 years to get this far but i am starting to se some results at last.
I've started converson of a Proxxon MF70 and last night i connected the first axle
But when i powered the card the motor started screaming in a very high pitch which got lower and lower until it stopped after aminute or so, and it got too warm to hold.
Is this normal?
It seems to work anyway since i can jog it and the driver on the board IS touchable so its not that hot.
The motor name is TEC SPH-54AB-090 (have not data sheet for it thou, its from some printer)
Running from a 12V 8Ah ATX psu.
Using a 2 years old hobbycnc card
/Ulf
Results 1 to 2 of 2
-
05-13-2008, 07:47 AM #1
Member
- Join Date
- Apr 2006
- Posts
- 24
Motor screams and gets hot while idle
-
05-14-2008, 06:52 AM #2
Member
- Join Date
- Apr 2006
- Posts
- 24
okey no matter. It's as supposed to be. it gets hot during idle. i've gotten answers from another place.
/Methuso
Reply With QuoteSimilar Threads
-
use satellite dish actuator motor as a stepper motor
By ozni in forum Stepper Motors / DrivesReplies: 7Last Post: 06-19-2010, 01:55 AM -
Problems with motor stalling due to motor/lead screw alignment
By Bimmerkc1 in forum DIY CNC Router Table MachinesReplies: 3Last Post: 01-25-2010, 01:12 AM -
G201, no holding power at idle
By Zumba in forum Gecko DrivesReplies: 3Last Post: 02-21-2008, 07:26 PM -
automatic idle-current reduction & belt drive ??
By Georg in forum DIY CNC Router Table MachinesReplies: 1Last Post: 11-06-2007, 10:11 PM -
Whine / squeal noises when machine idle
By bkraz in forum Bridgeport / Hardinge MillsReplies: 5Last Post: 02-09-2006, 12:29 PM
Posting Permissions
