I just picked up a Dyna Myte 2400 machine however there was no controler on it does anyone know where I could get one?
Thanks
Bill
I just picked up a Dyna Myte 2400 machine however there was no controler on it does anyone know where I could get one?
Thanks
Bill
You should just retrofit it as the stock controller is not very good and doesn't understand G-code directly. There is a thread here http://www.cnczone.com/forums/showthread.php?t=33770 about doing this with Mach3.
Chris.
List of parts sources for CNC builders - http://www.CNCsources.net
Dyna Mechtronics 4400C Conversion - CNC bed mill w/toolchanger to Mach3 conversion - http://www.cnczone.com/forums/showthread.php?t=50787