586,094 active members*
3,861 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Fadal > Inhibit spindle alarm

Thread: Inhibit spindle alarm

Results 1 to 2 of 2
  1. 02-15-2008, 05:06 PM #1
    bigbobr
    bigbobr is offline Registered
    Join Date
    Sep 2007
    Posts
    39

    Question Inhibit spindle alarm

    I have been programing, running a 16x22 Fadal vmc, with Fanuc 01,mc controls for about a year. So far not too many problems. Today I am throwing up an Alarm 1105 message- Inhibit spindle CMM, ATC not A... This is happening after a tool change, with various tools. Anyone have any clue to this?? Thanks
    Reply With Quote Reply With Quote
  2. 02-15-2008, 06:38 PM #2
    Neal
    Neal is offline Registered
    Send a message via AIM to Neal
    Join Date
    Mar 2003
    Posts
    900
    Look at sensor 805DV1. Look at the signal status screen at X7 bit 0. It runs thru board C002 at XT70A-19.
    That sensor may not be reading correctly or the ATC is not physically all the way home.

    Neal
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Inhibit vs phase chopping
    By stragenmitsuko in forum Open Source Controller Boards
    Replies: 0
    Last Post: 02-02-2008, 06:18 PM
  2. spindle alarm
    By bhupinder in forum Fanuc
    Replies: 1
    Last Post: 01-31-2008, 08:24 PM
  3. Spindle Alarm
    By phoodieman in forum Daewoo/Doosan
    Replies: 2
    Last Post: 03-17-2007, 01:06 AM
  4. alarm! spindle overcurrent
    By jianjianca in forum Bridgeport / Hardinge Mills
    Replies: 2
    Last Post: 04-27-2006, 04:35 AM
  5. Quesion regarding inhibit jumper settings for Fanuc drive
    By cncboy in forum CamSoft Products
    Replies: 1
    Last Post: 03-08-2005, 12:43 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules