[b.locke]

I have a VMX24 with Ultramax and the NNCP option
When tool length probing I get the following error some of the time
(TOOL DESTINATION OUT OF RANGE)
What I don’t understand is why this is happening. Anyone else seen this problem


O8200(MAIN TOUCH OFF TOOLS)
G65P8024D0.T9.U1.W1.F20.
(T IS THE LAST TOOL)
(U IS THE FIRST TOOL)
(D IS A SHIFT0)
(F IS THE FEED)
(W IS THE TOOL TO RETURN TO SPINDLE)
M30
%

O8023(VMX24 SET MAROS)
M27(ACTIVATE TOOL PROBE VMX24)
#528=19.2329(HURCO SPINDLE NOSE TO PROBE)
#529=1.1091(PROBE X)
#530=14.0411(PROBE Y)
M53(BLOW OFF PROBE)
G04P60
M63
M99
%

%
O8024(VMX MULTI-TOOL TOUCH OFF)
M98P8023
G91G28Z0

IF[#9NE#0]GOTO10
#9=30
N10IF[#21NE#0]GOTO1
#21=#20
N1IF[#21LE#20]GOTO2
#3000=195(U MUST BE LESS THAN T)
GOTO99
N2#139=#5043
#3004=2
(FIRST TOOL)
T#21
WHILE[#21LE#20]DO1
M6 T#21
#140=2000+#21
#21=#21+1
G54.1P1G0G90X#529Y#530
M27
G90G31Z-15.32F#9 THE ERROR COMES ON THIS LINE
#137=#5063
#[#140]=#137+#528
G4P400
(G91G28Z0)
END1
N99#3004=0
M6T#23
G90
M99

[sluggo]

I've never used a prode on a hurco, but I still might be able to help. Does the machine move at all on that line or does it error out as soon as it reads it? Also just out of curiosity since none of our hurcos have probes, can you use the probe with the ultimax ( or conversational )language?

[RON MEYER]

What version is the software? Is the probe Z minimum depth set too short in the probing setup for the tool being probed? There is a rapid Z position for each tool and a monimum Z depth at which the Z axis will stop if the tool reaches the minimum. Ron