[rchunter94]

I bought a use Takisawa MAC2 with 10M Fanuc control.
Tried to download a program, no alarms. It will punch out to the PC.
i have checked the cable and parameters and still no download.
Is it possible to get a aftermarket port to upload programs even if something wrong with the punch board??

[jolulank]

I hope this helps

first I go to the PROGRAM, then READ, then there is a PROG# and here you write down the number you want your program to be, basically the same you do have after your O, and then you press EXECUTE. After that you go to your computer and send your program.

Make sure you have all the pins in your cable right and also the terminal parameters.

Good luck

jlankenau

I bought a use Takisawa MAC2 with 10M Fanuc control.
Tried to download a program, no alarms. It will punch out to the PC.
i have checked the cable and parameters and still no download.
Is it possible to get a aftermarket port to upload programs even if something wrong with the punch board??

[dcoupar]

What software are you using to communicate? Is it configured to "wait" for the CNC?

Have you tried sending the same program you just downloaded to the PC back to the machine?

Do you have % signs at the top and bottom of the program?

Does LSK blink when you try to read?

[jose aguillon]

it´s there message right after the larm came up.
it has to be (bge 807) go to paramerer and chaged to com 2 or in your pc set up com 2 instead of com 1 and That should work.

[rchunter94]

Jose,
can you send the parameters that are loaded for these numbers that relate to rs232c.

20
21
22
23

5010
5011
5012
5013
etc.

Thanks, PC only has COM port 1.