I just finally got this up and running on my VF-5, but when I go to touch off an endmill, I get an alarm calling a z over travel. It then inputs a distance of -4724. in my z offset. If I set the tool as a drill in the IPS it will offset it no problem. I know the tool is supposed to rotate in reverse to find the high spot and touch off on the tool probe. Any ideas?

As to the aforementioned item I think I have figured out the problem there. But I have another question. I have everything calibrated and all is working well, but when I touch off a single axis...namely "Z", my tool positions itself .197 above the z plane. Can anyone help?