Out of the blue my arrow keys stopped working to move my X,Y and Z
Any suggestions
Out of the blue my arrow keys stopped working to move my X,Y and Z
Any suggestions
Go to config>hotkeys and reset them.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Also check to make sure jogging is turned on, and be aware that you can't jog on all the screens.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks Ger
I remembered what it was while lying in bed last night.
For future ref. can you remind me how to get to the virtual keys w/ the mouse. I cant seem to remember where to find that option.
Thanks again