I am trying to run Master5. When I load the software, it runs fine for about half a minute. Then a window pops up and says RPC Server Unavailable....Then I am caught in a loop, I cannot get rid of this window. I close Master5, and start it again, which crashes and restarts my computer.
Please help....
Thread: RPC Server?
Results 1 to 4 of 4
-
08-26-2004, 02:02 PM #1
Registered
- Join Date
- Aug 2004
- Posts
- 21
RPC Server?
-
09-01-2004, 05:09 PM #2
Registered
- Join Date
- Aug 2004
- Posts
- 21
Please help. I am a complete rookie at this game, and am very frustrated. I do not have a control board hooked up right now, I just want to play with the software and become familiar with it. Could this be the reason for the error?
-
09-01-2004, 07:03 PM #3
Chip Sweeper
- Join Date
- Aug 2003
- Posts
- 79
What operating system are you using.
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
-
09-02-2004, 02:41 PM #4
Registered
- Join Date
- Aug 2004
- Posts
- 21
I'm using XP, but I think I found out what my problem is. I talked to an IT guy yesterday, and he thinks I have a virus. Sux to be me right now, but he said there is a patch and can be fixed.
Reply With Quote
Posting Permissions
