Hello.
I need postprocessor for Daewoo lathe puma 240M.
I use edgecam 11.0
Please help me.
Bye
Hello.
I need postprocessor for Daewoo lathe puma 240M.
I use edgecam 11.0
Please help me.
Bye
here's one for a Doosan S390L, which is almost the same.
It's not completely finished, but it'll get you going.
Tkank you but this is for 2 AX LATHE Doosan .
240M have 3AX.
this post processor don't work whith edgecam 11.0 .
bye
Have you talked to your reseller they can usually help you create your post. It is difficult to find a specific post for your machine, no machine is identical. You will probably have to modify a post from a machine that is similar to your machine.
No matter how good you are, there is always someone better!!!