586,121 active members*
3,691 visitors online*
Register for free
Login
IndustryArena Forum > CAM Software > BobCad-Cam > 2 speeds plunge feed?

Thread: 2 speeds plunge feed?

Results 1 to 5 of 5
  1. 05-06-2008, 04:43 AM #1
    Claude Boudreau
    Claude Boudreau is offline Registered
    Join Date
    Feb 2007
    Posts
    505

    Question 2 speeds plunge feed?

    I remember pocketing with mach3 wizard and I was surprise that my plunge feed was fast at first and just before touching the work it change to a slower speed, Is this possible with Bobcad?
    Reply With Quote Reply With Quote
  2. 05-06-2008, 05:59 AM #2
    smurph
    smurph is offline Registered
    Join Date
    Feb 2007
    Posts
    77
    Yes, v22 will rapid to the R plain and then start moving at Z feed rate.

    Steve
    Reply With Quote Reply With Quote
  3. 05-07-2008, 01:05 AM #3
    Claude Boudreau
    Claude Boudreau is offline Registered
    Join Date
    Feb 2007
    Posts
    505
    What about V.21?
    Reply With Quote Reply With Quote
  4. 05-07-2008, 02:26 PM #4
    The One
    The One is offline Registered
    Join Date
    Aug 2003
    Posts
    449
    No, Version 21 does not support this type of functionality. It will always produce a feed move from a single rapid plane.

    Regards
    Reply With Quote Reply With Quote
  5. 05-08-2008, 10:48 PM #5
    Claude Boudreau
    Claude Boudreau is offline Registered
    Join Date
    Feb 2007
    Posts
    505
    Is it possible to modify the code with Mach3 to do it?

    Thanks again great One!
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Feed/speed for plunge or ramping
    By mrk in forum MetalWork Discussion
    Replies: 8
    Last Post: 09-07-2016, 08:46 PM
  2. Ignoring Feed Speeds
    By xichanceix in forum DeskCNC Controller Board
    Replies: 1
    Last Post: 12-18-2007, 03:55 AM
  3. Plunge Feed driving me nuts
    By DRP in forum Mach Software (ArtSoft software)
    Replies: 0
    Last Post: 09-12-2007, 04:53 PM
  4. General Feed and Speeds?
    By BulleTxMagneT in forum Uncategorised CAM Discussion
    Replies: 1
    Last Post: 08-18-2007, 08:41 AM
  5. Which is Best - Deeper Plunge/Faster Feed
    By bill south in forum MetalWork Discussion
    Replies: 7
    Last Post: 01-10-2007, 06:42 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules