586,106 active members*
3,068 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Gecko Drives > Gecko 340 limit,gain,damping zero position?

Thread: Gecko 340 limit,gain,damping zero position?

Results 1 to 2 of 2
  1. 05-07-2008, 03:16 PM #1
    Preston E
    Preston E is offline Registered
    Join Date
    Jun 2006
    Posts
    33

    Gecko 340 limit,gain,damping zero position?

    Hello,

    I have several 340's that were used by a friend and the settings are in the mid range approximately.

    The Installation Notes state to turn the Limit trim pot 1/4 to 1/2, Gain turn off, and Damping 1/4 turn.

    Where is the off position. Fully clockwise or fully counter clockwise? And is this true for each of the 3 trim pots?

    I've looked at all of the Gecko instructions and cannot find this anywhere.

    Thanks for the help,

    Regards,

    Preston
    Reply With Quote Reply With Quote
  2. 05-07-2008, 09:10 PM #2
    Preston E
    Preston E is offline Registered
    Join Date
    Jun 2006
    Posts
    33
    Ok, they were mounted in the control panel and I could not see them well at the angle and placement.

    Had to take one out and with my optivisors on I could see the little 1,2,3...

    Turning all the way counter clockwise zeros the little devils...

    Regards,

    Preston
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Gain, Damping, Limit
    By THend in forum Gecko Drives
    Replies: 1
    Last Post: 04-10-2008, 09:17 PM
  2. Filling steel tube with cement for damping/mass?
    By stag53 in forum Mechanical Calculations/Engineering Design
    Replies: 6
    Last Post: 11-26-2007, 08:39 PM
  3. Vibration Damping
    By Geof in forum Mechanical Calculations/Engineering Design
    Replies: 3
    Last Post: 11-08-2007, 09:44 PM
  4. Newbie questions gecko drive limit ?
    By Calico in forum Gecko Drives
    Replies: 0
    Last Post: 04-03-2005, 11:15 AM
  5. To Gecko, or not to Gecko...that is the question!
    By samualt in forum Gecko Drives
    Replies: 11
    Last Post: 09-23-2003, 02:42 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules