Hi Folks,
I have a stepper motor that is rated for 8.1 amps.
Would I get ok performance using the G210.
Thanks,
Bubba
Hi Folks,
I have a stepper motor that is rated for 8.1 amps.
Would I get ok performance using the G210.
Thanks,
Bubba
You'll get about 86% of the rated holding torque running a Gecko at 7 amps.
Gerry
UCCNC 2017 Screenset
http://www.thecncwoodworker.com/2017.html
Mach3 2010 Screenset
http://www.thecncwoodworker.com/2010.html
JointCAM - CNC Dovetails & Box Joints
http://www.g-forcecnc.com/jointcam.html
(Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
Thanks Gerry,
So it will not possibly cause damage to the drive?
Thanks,
Joe
No. The drive will limit its output to 7A.
Mariss